Basic router configuration Pc#

Yes, the PC is using the default gateway router to forward the traffic. IPv6 address = 200 1:db 8:acad : 3::1 Question:ДЇrom the command line of PC3 ping the ISP address 209.165.200.226. The addresses assigned to the S0/1/1 interface on R1 are:

From the CLI on R2 ping the S0/1/1 address of R1 for both IPv4 and IPv6.

Using the command line at PC3, ping the IPv4 and IPv6 addresses for PC4.

Save the running configuration to the startup configuration file.Д¬lose configuration window Step 3: Verify n etwork connectivity.

R2(config- if)# ipv6 address fe80:: 1 :d link-local R2(config- if)# description Link to Internet R2(config- if)# ipv6 address fe80:: 1 :c link-local

R2 (config- if)# ipv6 address fe80:: 2 :b link-local R2 (config- if)# description Connection to S4 R2 (config- if)# ipv6 address fe80::2:a link-local R2 (config- if)# description Connection to S3 Configure all four interfaces with descriptions.

Configure all four interfaces on the router with the IPv4 and IPv6 addressing information from the addressing table above.

R2 (config)# banner motd $ WARNING Authorized Users Only! $

Create a banner that warns anyone accessing the device that unauthorized access is prohibited.

Assign cisco as the vty password, configure the vty lines to accept SSH connections only, configure sessions to disconnect after six minutes of inactivity, and enable login using the local database.

To prevent console messages from interrupting commands, use the logging synchronous command.

Assign cisco as the console password, configure sessions to disconnect after six minutes of inactivity, and enable login.

Generate a set of crypto keys with a 1024 bit modulus.

R2 (config)# usern ame SSHadmin secret 55 Hadm!n

Basic router configuration password#

Configure the username SSHadmin with an encrypted password of 55 H a dm !n.

Disable DNS lookup to prevent the router from attempting to translate incorrectly entered commands as though they were host names.

Set the domain name of the router to.

Configure c1sco1234 as the encrypted privileged EXEC mode password.

Assign a device name of R2 to the router.

Configure the IPv4 and IPv6 addresses on PC4 as listed in the Addressing Table.

Configure the IPv4 and IPv6 addresses on PC3 as listed in the Addressing Table.

Instructions Part 1: Configure Devices and Verify Connectivity Step 1: Configure the PC interfaces. For review purposes, this lab provide s the commands necessary for specific router configurations. In Part 2, y ou will use SSH to connect to the router remotely and utilize the IOS commands to retri eve information from the device to answer questions about the router. In Part 1, you will complete basic configurations and interface settings on the router. This is a comprehensive review of previously covered IOS router commands. The R1 router and the devices connected to it have been configured. This activity requires you to configure the R2 router using the settings from the Addressing Table and the specifications listed.

Basic router configuration software#

Retrieve hardware and software information from the router.

Assign static IPv4 and IPv6 addresses to the PC interfaces.

Part 1 : Configure Devices and Verify Connectivity